White Papers

Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#show storm-control multicast gigabitethernet 1/1
Multicast storm control configuration
Interface Direction Packets/Second
-----------------------------------------
Te 2/2 Ingress 5
Dell#
storm-control multicast (Interface)
Configure the percentage of multicast traffic allowed on the interface.
Syntax
storm-control multicast packets_per_second in
To disable multicast storm control on the interface, use the no storm-control multicast
packets_per_second in command.
Parameters
packets_per_sec
ond
Enter the packets per second of broadcast traffic allowed into the network. The
range is from 0 to 33554368.
Command Modes INTERFACE (conf-if-interface-slot/port)
Supported Modes Programmable-Mux (PMUX)
Full–Switch Mode
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Supported on the M I/O Aggregator.
storm-control broadcast (Configuration)
Configure the percentage of broadcast traffic allowed in the network.
Syntax
storm-control broadcast [packets_per_second in]
To disable broadcast rate-limiting, use the no storm-control broadcast
[packets_per_second in] command.
Parameters
packets_per_sec
ond
Enter the packets per second of broadcast traffic allowed into the network. The
range is from 0 to 33554368.
Defaults none
Command Modes CONFIGURATION (conf)
Supported Modes Full–Switch Mode
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
Storm Control 1125