White Papers

stack-unit priority
Configure the ability of a switch to become the management unit of a stack.
Syntax
stack-unit stack-number priority 1-14
Parameters
stack-number Enter the stack member unit identifier.
1–14 This preference parameter allows you to specify the management priority of one
backup switch over another, with 0 the lowest priority and 14 the highest. The
switch with the highest priority value is chosen to become the management unit if
the active management unit fails or on the next reload.
Defaults 0
Command Modes CONFIGURATION
Supported Modes All Modes
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.6.(0.0) Supported on the FN I/O Aggregator.
9.3(0.0) Supported on the M I/O Aggregator.
Usage
Information
This command is supported on the M I/O, FN410S, and FN410T Aggregators.
Related
Commands
● reload – reboots Dell Networking Operating System (OS).
● show system – displays the status of all stack members or a specific member.
stack-unit provision
Preconfigure a logical stacking ID of a switch that joins the stack. This is an optional command that is executed on the
management unit.
Syntax
stack-unit 0–5] provision {MXL-10/40GbE}
Parameters
0–5 Enter a stack member identifier, from 0 to 5, of the switch that you want to add to
the stack.
MXL-10/40GbE Enter the model identifier of the switch to be added as a stack member. This
identifier is also referred to as the provision type.
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
● reload — reboots the system.
● show system — displays the status of all stack members or a specific member.
stack-unit renumber
Change the stack member ID of any stack member or a stand-alone unit.
Syntax
stack-unit 0-5 renumber 0-5
Stacking Commands 1119