White Papers

Version Description
9.6.(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage
Information
This command is supported on the M I/O, FN410S, and FN410T Aggregators.
This command is used to reset the stack-unit. The master unit can also be power cycled using this
command.
redundancy disable-auto-reboot
Prevent the switch stack management unit from rebooting if it fail.
Syntax
redundancy disable-auto-reboot stack-unit [0–5 | members]
To return to the default, use the no redundancy disable-auto-reboot stack-unit [0–5 |
members] command.
Defaults Disabled (the failed switch is automatically rebooted).
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When the command is given as redundancy disable-auto-reboot stack-unit, it prevents the
switch stack management unit and standby unit from rebooting if they fail.
When a particular unit number in the range from 0 to 5 is issued as part of the CLI, it prevents that
particular unit from rebooting after failure.
When members are issued as part of the CLI, all the units part of the stack are prevented from rebooting
after failure.
The unit does not reboot until it is manually rebooted.
Related
Commands
show redundancy — displays the current redundancy status.
redundancy force-failover stack-unit
Force the standby unit in the stack to become the management unit.
Syntax
redundancy force-failover stack-unit
Defaults Not enabled.
Command Modes EXEC Privilege
Supported Modes Full–Switch Mode
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Stacking Commands 1113