White Papers

Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
logging monitor — sets the logging monitor parameters.
terminal monitor — sends system messages to the terminal/monitor.
default logging trap
Return to the default settings for logging messages to the Syslog servers.
Syntax
default logging trap
Defaults level = 6 or informational
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
logging trap — limit messages logged to the Syslog servers based on severity.
logging
Configure an IP address or host name of a Syslog server where logging messages are sent. You can configure multiple logging
servers of both IPv4 and/or IPv6.
Syntax
logging {ip-address | ipv6–address |hostname} {{udp {port}} | {tcp {port}}
To disable logging, use the no logging command.
Parameters
ip-address Enter the IPv4 address in dotted decimal format.
ipv6-address Enter the IPv6 address in the x:x:x:x::X format.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
hostname Enter the name of a host already configured and recognized by the switch.
udp Enter the keyword udp to enable transmission of log message over UDP followed
by port number. The default port is 514
tcp Enter the keyword tcp to enable transmission of log message over TCP followed
by port number.
Defaults Disabled.
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.5(0.0) Introduced udp and tcp keywords on the MXL 10/40GbE Switch.
1102 Simple Network Management Protocol (SNMP) and Syslog