White Papers

Dell(conf)#snmp-server community guest ro snmp-ro-acl
Dell(conf)#
Related
Commands
ip access-list standard — names (or selects) a standard access list to filter based on IP address.
show running-config — displays the current SNMP configuration and defaults.
snmp-server contact
Configure contact information for troubleshooting this SNMP node.
Syntax
snmp-server contact text
To delete the SNMP server contact information, use the no snmp-server contact command.
Parameters
text Enter an alphanumeric text string, up to 55 characters long.
Defaults none
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
snmp-server enable traps
Enable SNMP traps.
Syntax
snmp-server enable traps [notification-type] [notification-option]
To disable traps, use the no snmp-server enable traps [notification-type]
[notification-option] command.
Parameters
notification-type Enter the type of notification from the following list:
● ecfm — Notification of changes to ECFM.
● entity — Notification of changes to entity.
● envmon — For Dell Networking device notifications when an environmental
threshold is exceeded.
● eoam — Notification of changes to the EOAM state.
● ets — Notification of changes to the ets traps.
● fips — Notification of changes to the FIP snooping state.
● lacp — Notification of changes.
● pfc — Notification of changes to pfc traps.
● snmp — Notification of RFC 1157 traps.
● stp — Notification of a state change in the spanning tree protocol (RFC 1493).
● vrrp — Notification of a state change in a VRRP group.
● xstp — Notification of a state change in MSTP (802.1s), RSTP (802.1w), and
PVST+.
notification-
option
For the envmon notification-type, enter one of the following optional parameters:
● temperature
For the snmp notification-type, enter one of the following optional parameters:
1090 Simple Network Management Protocol (SNMP) and Syslog