White Papers

show snmp user
Display the information configured on each SNMP user name.
Syntax
show snmp user
Command Modes
● EXEC
● EXEC Privilege
Supported Modes Full–Switch Mode
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#show snmp user
User name: v1v2creadu
Engine ID: 0000178B02000001E80214A8
storage-type: nonvolatile active
Authentication Protocol: None
Privacy Protocol: None
Dell#
snmp context
Enables you to map a BGP VRF instance within an SNMP context through community mapping in SNMPv2c and SNMPv3.
Syntax
[no] snmp context [context name]
Parameters
context name
Enter a unique name for the context.
Defaults None
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14.1.0 Introduced on S4810 and S4820T.
9.13(0.0) Introduced on all DNOS platforms.
Usage
Information
Use this command to map SNMP context to a VRF instance within a community in SNMPv2c and
SNMPv3. The no version of this command turns off this feature.
snmp context
Configure SNMPv3 context name to map multiple OSPFv3 VRF instances.
Syntax
snmp context {context-name}
To clear snmp context, use the no snmp context {context-name} command.
Parameters
context-name Enter the SNMP context name. The maximum length is 32 alphanumeric
characters.
Simple Network Management Protocol (SNMP) and Syslog 1087