White Papers

sflow max-header-size extended
Set the maximum header size of a packet to 256 bytes.
Syntax
sflow max-header-size extended
To reset the maximum header size of a packet, use the[no] sflow max-header-size extended
command.
Parameters
extended Enter the keyword extended to copy 256 bytes from the sample packets to
sFlow datagram.
Defaults 128 bytes
Command Modes
CONFIGURATION
INTERFACE
Supported Modes Full–Switch Mode
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the FN IOM.
9.7(0.0) Introduced on the MXL switch.
Example
Dell(conf)#sflow max-header-size extended
sflow polling-interval (Global)
Set the sFlow polling interval at a global level.
Syntax
sflow polling-interval interval value
To return to the default, use the no sflow polling-interval interval command.
Parameters
interval value Enter the interval value in seconds. The range is from 15 to 86400 seconds. The
default is 20 seconds.
Defaults 20 seconds
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The polling interval for an interface is the maximum number of seconds between successive samples of
counters sent to the collector. This command changes the global default counter polling (20 seconds)
interval. You can configure an interface to use a different polling interval.
1074 sFlow