White Papers

show userroles
Display information on all defined user roles.
Syntax
show userroles
Example
Dell#show userroles
Role Inheritance Modes
netoperator Exec
netadmin Exec Config Interface Line Router IP
Route-map Protocol MAC
secadmin Exec Config
sysadmin Exec Config Interface Line Router IP
Route-map Protocol MAC
netoperator
testadmin netadmin Exec Config Interface Line Router IP
Route-map Protocol MAC
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9000, S6000, S4820T, S4810, MXL.
Related
Commands
userrole — creates user roles for the role-based security model.
ssh
Open an SSH connection specifying the host name, username, port number and version of the SSH client.
Dell Networking OS supports both inbound and outbound SSH sessions using IPv4 addressing. Inbound SSH supports accessing
the system through the management interface as well as through a physical Layer 3 interface.
Syntax
ssh {hostname | ipv4 address} [-| username | -p port-number|-v {1|2}]
Parameters
hostname (OPTIONAL) Enter the IP address or the host name of the remote device.
ipv4 address (OPTIONAL) Enter the IP address in dotted decimal format A.B.C.D.
-l username (OPTIONAL) Enter the keyword -l followed by the user name used in this SSH
session. The default is the user name of the user associated with the terminal.
-p port-number (OPTIONAL) Enter the keyword -p followed by the port number. The range is from
1 to 65536. The default is 22.
-v {1 | 2} (OPTIONAL) Enter the keyword -v then the SSH version 1 or 2. The default is the
version from the protocol negotiation.
Defaults As shown in the Parameters section.
Command Modes EXEC Privilege
Supported Modes All Modes
Command
History
Version Description
9.10(0.0) Removed the support for hmac-sha2-256-96 algorithm.
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
Security 1059