White Papers

exec-banner
Enable the display of a text string when the user enters EXEC mode.
Syntax
exec-banner
To disable the banner on terminal lines, use the no exec-banner command.
Defaults Enabled on all lines (if configured, the banner appears).
Command Modes LINE
Supported Modes All Modes
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.3(0.0) Supported on the M I/O Aggregator.
Usage
Information
Optionally, use the banner exec command to create a text string that is displayed when you access
EXEC mode. This command toggles that display.
Related
Commands
banner exec— configures a banner to display when entering EXEC mode.
line — enables and configures console and virtual terminal lines to the system.
access-class
Restrict incoming connections to a particular IP address in a defined IP access control list (ACL).
Syntax
access-class access-list-name
To delete a setting, use the no access-class command.
Parameters
access-list-name Enter the name of an established IP Standard ACL.
Defaults Not configured.
Command Modes LINE
Supported Modes Full–Switch
Command
History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
line — applies an authentication method list to the designated terminal lines.
ip access-list standard — names (or selects) a standard access list to filter based on the IP address.
ip access-list extended — names (or selects) an extended access list based on the IP addresses or
protocols.
enable password
Change the password for the enable command.
Syntax
enable password [level level] [encryption-type] password
To delete a password, use the no enable password [encryption-type] password [level
level] command.
1022 Security