White Papers

Apply a Redirect-list to an Interface using a Redirect-group
IP redirect lists are supported on physical interfaces as well as VLAN and port-channel interfaces.
NOTE: When you apply a redirect-list on a port-channel, when traffic is redirected to the next hop and the destination
port-channel is shut down, the traffic is dropped. However, the traffic redirected to the destination port-channel is
sometimes switched.
To apply a redirect list to an interface, use the following command in Interface mode. You can apply multiple redirect-lists to
a redirect-group. It is also possible to create two or more redirect-groups on one interface for backup purposes.
Table 66. Apply a Redirect-list to an Interface using a Redirect-group
Command Syntax Command Mode Purpose
ip redirect-group redirect-
list-name
INTERFACE Apply a redirect list (policy-based
routing) to an interface. redirect-list-
name is the name of a redirect list to
apply to this interface. FORMAT: up
to 16 characters. Delete the redirect
list from this interface with the [no] ip
redirect-group command.
In this example, the list “xyz” is applied to the tenGigabitEthernet 4/0 interface.
Applying a Redirect-list to an Interface Example:
DellEMC(conf-if-te-2/0)#ip redirect-group xyz
DellEMC(conf-if-te-2/0)#
Applying a Redirect-list to an Interface Example:
DellEMC(conf-if-te-1/0)#ip redirect-group test
DellEMC(conf-if-te-1/0)#ip redirect-group xyz
DellEMC(conf-if-te-1/0)#show config
!
interface TenGigabitEthernet 1/0
no ip address
ip redirect-group test
ip redirect-group xyz
shutdown
DellEMC(conf-if-te-1/0)#
In addition to supporting multiple redirect-lists in a redirect-group, multiple redirect-groups are supported on a single interface.
The Dell EMC Networking OS has the capability to support multiple groups on an interface for backup purposes.
Show Redirect List Configuration
To view the configuration redirect list configuration, use the following command in EXEC mode:
Table 67. Showing Redirect List Configuration
Command Syntax Command Mode Purpose
show ip redirect-list
redirect-list-name
EXEC View the redirect list configuration and
the associated interfaces.
show cam pbr
EXEC View the redirect list entries
programmed in the CAM.
show cam-usage
View the redirect list configuration using the show ip redirect-list redirect-list-name command. The non-
contiguous mask displays in dotted format (x.x.x.x). The contiguous mask displays in /x format.
DellEMC#show ip redirect-list explicit_tunnel
IP redirect-list explicit_tunnel:
Defined as:
seq 5 redirect tunnel 1 track 1 tcp 155.55.2.0/24 222.22.2.0/24, Track 1 [up], Next-hop
reachable (via Te 1/32)
seq 10 redirect tunnel 1 track 1 tcp any any, Track 1 [up], Next-hop reachable (via Te
Policy-based Routing (PBR)
607