White Papers

Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage
Information
LACP Modes
Mode Function
active An interface is in an active negotiating state in this mode. LACP runs on any link
configured in the active state and also automatically initiates negotiation with other
ports by initiating LACP packets.
passive An interface is not in an active negotiating state in this mode. LACP runs on any
link configured in the passive state. Ports in a passive state respond to negotiation
requests from other ports that are in active states. Ports in a passive state respond
to LACP packets
off An interface cannot be part of a dynamic port channel in off mode. LACP does not
run on a port configured in off mode.
port-channel-protocol lacp
Enable LACP on any LAN port.
Syntax
port-channel-protocol lacp
To disable LACP on a LAN port, use the no port-channel-protocol lacp command.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
Link Aggregation Control Protocol (LACP) 959