White Papers

Defaults Disabled
Command Modes CONFIGURATION
Command
History
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
Enables periodic audits of the software and hardware copies of the IPv4 forwarding table.
clear alarms
Clear alarms on the system.
Syntax
clear alarms
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage
Information
This command clears alarms that are no longer active. If an alarm situation is still active, it is seen in the
system output.
clear average-power
Reset the average power and average power start time.
Syntax
clear average-power stack-unit {stack-unit-number}
Parameters
stack-unit-
number
Enter the stack unit number.
Defaults None
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.11(2.1P1) Introduced on all Dell EMC Networking OS platforms
86 Control and Monitoring