White Papers

Defaults LPM is not partitioned with Partition 1 and therefore /65 to /128 prefixes are not converted to /64
prefixes and are installed and saved in LPM. All the packets for those routes traverse through the default
route path.
Command Modes CONFIGURATION
Command
History
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048–ON.
9.8(0.0P2) Introduced on the S3048–ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.3(0.1) Introduced on the S6000.
Usage
Information
You can partition the LPM table to store IPv6 prefixes greater than /64 mask length. Requires reboot of
the switch to take effect as the SDK handles this only during its initialization.
clear ipv6 fib
Clear (refresh) all forwarding information base (FIB) entries on a linecard or stack unit.
Z9500
Syntax
clear ipv6 fib linecard slot-id
Parameters
slot Enter the slot number to clear the FIB.
linecard slot-id Enter the slot ID of a Z9500 line card. Valid slot IDs are from 0 to 2.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the C-Series and S-Series.
7.4.1.0 Introduced on the E-Series.
854 IPv6 Basics