White Papers

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.0 Added the ingress-port parameter for the S4810.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage
Information
By default, Dell EMC Networking OS distributes incoming traffic based on a hash algorithm using the
following criteria:
● IP source address
● IP destination address
● TCP/UDP source port
● TCP/UDP destination port
management route
Configure a static route that points to the Management interface or a forwarding router.
Z9500
Syntax
management route {ip-address mask | ipv6-address 1.1.1.1prefix-length}
{forwarding-router-address | managementethernet | fortyGigE | vlan |
tengigabitethernet }
To remove a static route, use the no management route command.
Parameters
ip-address mask Enter an IP address (dotted decimal format) and mask (/prefix format) of the
destination subnet.
ipv6-address
prefix-length
Enter an IPv6 address (x:x:x:x::x format) and mask (/prefix format) of the
destination subnet. Enter the IPv6 address in the x:x:x:x::x format followed by the
prefix length in the /x format.
The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
forwarding-
router-address
Enter an IP address (dotted decimal format) or an IPv6 address (x:x:x:x::x format)
of a forwarding router.
managementethe
rnet
Enter the keyword managementethernet for the Management interface on the
Primary RPM.
fortyGigE Enter the keyword fortyGigE to specify a forty Gigbit Ethernet interface.
vlan Enter the keyword vlan to specify a vlan interface.
tengigabitethern
et
Enter the keyword tengigabitethernet to specify a ten Gigabit Ethernet interface.
Defaults Not configured.
Command Modes CONFIGURATION
804 IPv4 Routing