White Papers

upgrade fpga-image system fpga booted
Use this command to upgrade the FPGA devices in the Z9500 Route Processor and Control Processor CPUs using the currently
running Dell Networking operating-system image (and only when required by the upgrade procedure in the Z9500 release
notes).
Z9500
Syntax
upgrade fpga-image system fpga booted
Defaults none
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
9.0.0.0 Introduced on the Z-Series.
Example
Dell# upgrade fpga-image system fpga booted
Current FPGA information in the system:
=======================================
Card FPGA Name Current Version New Version
------------------------------------------------------------------------
CP FPGA 0x14 0x13
***********************************************************************
* Warning - Upgrading FPGA is inherently risky and should *
* only be attempted when necessary. A failure at this upgrade may *
* cause a board RMA. Proceed with caution ! *
***********************************************************************
Upgrade FPGA image for system [yes/no]: yes
FPGA upgrade in progress!!! Please do NOT power off the unit
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Usage
Information
Do not restart the switch while an upgrade is progressing. Restarting the chassis during an upgrade may
corrupt critical boot components.
When an upgrade of FPGA devices successfully completes, the switch reloads automatically.
Related
Commands
● upgrade fpga-image linecard booted — upgrades the FPGA devices in Z9500 line cards.
upgrade system
Upgrade the Dell EMC Networking OS image on all Z9500 CPUs, including the Control Processor, Route Processor, and line
cards. To upgrade the boot flash or boot selector image, use the upgrade boot command.
Syntax
upgrade system {flash: | ftp: | nfsmount: | scp: | stack-unit {stack-unit-
id | all} | tftp: | usbflash:} file-url {A: |B:}
Parameters
system Enter the keyword system to upgrade the operating system (OS) image.
72 File Management