White Papers

Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
8.3.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the C-Series and S-Series.
Usage
Information
When enabled, the system begins creating entries in the binding table for the specified VLANs.
NOTE: Learning only happens if there is a trusted port in the VLAN.
Related
Commands
ip dhcp snooping trust — configures an interface as trusted.
ipv6 dhcp snooping vlan
Enable ipv6 DHCP Snooping on VLAN or range of VLANs.
Syntax
[no] ip dhcp snooping vlan vlan-id
To disable the ipv6 dhcp snooping on VLAN basis or range of VLAN, use the no ipv6 dhcp snooping
vlan <vlan-id> command.
Parameters
vlan-id Enter the name of a VLAN id or list of the VLANs to enable DHCP Snooping.
Defaults Disabled
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S6000, S6000-ON, and Z-Series.
ip dhcp source-address-validation
Enable the IP Source Guard.
Syntax
[no] ip dhcp source-address-validation [ipmac] [vlan vlan-id]
604 Dynamic Host Configuration Protocol (DHCP)