White Papers

Table 5. Output Description for show running–config buffer–threshold
command (continued)
Field Description
resume-threshold-value Buffer offset limit at which the port resumes the
peer in KB.
Example
Dell#show run buffer-threshold
!
dcb-buffer-threshold test1
pfc priority 0 buffer-size 40
pfc priority 3 buffer-size 50
!
dcb-buffer-threshold test2
pfc priority 0 buffer-size 80 pause-threshold 50
!
dcb-buffer-threshold test3
pfc priority 0 buffer-size 80 pause-threshold 60 resume-threshold 30
On interface in which PFC is not enabled:
Dell#show interface tengigabitethernet 0/20 pfc buffer-threshold
The following table describes the output fields displayed for the show interface pfc buffer-
threshold command:
Table 6. Output Description for show interface pfc buffer–threshold
command
Field Description
queue Number of the queue
lossless Whether the queue is a lossy or lossless queue
for which buffer threshold is configured
buffer-size Ingress buffer size
pause-threshold-value Buffer limit at which the port sends the pause to
peer in KB.
resume-threshold-value Buffer offset limit at which the port resumes the
peer in KB.
shared threshold weight Weightage of the priorities on the shared buffer
size in the system.
dcb pfc-total-buffer-size
Configure the total buffer size for PFC in kilobytes.
Syntax
dcb pfc-total-buffer-size <value> linecard <0-2/all> port-set <0-3/all>[no]
dcb pfc-total-buffer-size <value> linecard <0-2/all> port-set <0-3/all>
Parameters
all Configure on all linecards.
Default 7488
Command Modes CONFIGURATION mode
526 Data Center Bridging (DCB)