White Papers

● ieee-v2: configures the port to use IEEE 802.1az (Draft 2.5).
Defaults Auto
Command Modes INTERFACE PROTOCOL LLDP
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the Z9500.
Usage
Information
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Configure DCBX operation at the INTERFACE level on a switch or globally on the switch. To verify the
DCBX configuration on a port, use the show interface dcbx detail command.
debug dcbx
Enable DCBX debugging.
Syntax
debug dcbx {all | auto-detect-timer | config-exchng | fail | mgmt |
resource | sem | tlv}
To disable DCBX debugging, use the no debug dcbx command.
Parameters
{all | auto-
detect-timer |
config-exchng |
fail | mgmt |
resource | sem |
tlv}
Enter the type of debugging, where:
● all: enables all DCBX debugging operations.
● auto-detect-timer: enables traces for DCBX auto-detect timers.
● config-exchng: enables traces for DCBX configuration exchanges.
● fail: enables traces for DCBX failures.
● mgmt: enables traces for DCBX management frames.
● resource: enables traces for DCBX system resource frames.
● sem: enables traces for the DCBX state machine.
● tlv: enables traces for DCBX TLVs.
Defaults none
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the Z9500.
fcoe priority-bits
Configure the FCoE priority advertised for the FCoE protocol in application priority TLVs.
Syntax
fcoe priority-bits priority-bitmap
To remove the configured FCoE priority, use the no fcoe priority-bits command.
Parameters
priority-bitmap Enter the priority-bitmap range. The range is from 1 to FF.
Data Center Bridging (DCB) 509