White Papers

Number of Traffic Classes is 8
Admin mode is on
Admin Parameters :
------------------
Admin is enabled
PG-grp Priority# BW-% BW-COMMITTED BW-PEAK TSA
% Rate(Mbps) Burst(KB) Rate(Mpbs) Burst(KB)
----------------------------------------------------------------------------------
0 0,1,2,4,5,6,7 50 400 100 4000 400 ETS
1 3 50 - - - - ETS
2 - - - - - -
3 - - - - - -
4 - - - - - -
5 - - - - - -
6 - - - - - -
7 - - - - - -
Remote Parameters :
-------------------
Remote is disabled
Local Parameters :
------------------
Local is enabled
PG-grp Priority# BW-% BW-COMMITTED BW-PEAK TSA
% Rate(Mbps) Burst(KB) Rate(Mpbs) Burst(KB)
----------------------------------------------------------------------------------
0 0,1,2,4,5,6,7 50 400 100 4000 400 ETS
1 3 50 - - - - ETS
2 - - - - - -
3 - - - - - -
4 - - - - - -
5 - - - - - -
6 - - - - - -
7 - - - - - -
DCBX Commands
advertise dcbx-tlv
On a DCBX port with a manual role, configure the PFC and ETS TLVs advertised to DCBX peers.
Syntax
advertise dcbx-tlv {ets-conf | ets-reco | pfc} [ets-conf | ets-reco | pfc]
[ets-conf | ets-reco | pfc]
To remove the advertised ETS TLVs, use the no advertise dcbx-tlv command.
Parameters
{ets-conf | ets-
reco | pfc}
Enter the PFC and ETS TLVs advertised, where:
● ets-conf: enables the advertisement of ETS configuration TLVs.
● ets-reco: enables the advertisement of ETS recommend TLVs.
● pfc: enables the advertisement of PFC TLVs.
Defaults All PFC and ETS TLVs are advertised.
Command Modes PROTOCOL LLDP
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the Z9500.
Usage
Information
You can configure the transmission of more than one TLV type at a time; for example: advertise
dcbx-tlv ets-conf ets-reco.
Data Center Bridging (DCB) 507