White Papers

Version Description
9.7(0.0) Introduced on the Z9500.
Usage
Information
By default, iSCSI is enabled on the unit and the flow control is enabled on all of the interfaces. It is also
acts as defaults when the link-level flow control is enabled on one or more interfaces. To enable DCB, do
one of the following:
● Apply the dcb-map command with the no pfc-mode command on to all the interfaces.
● Disable flow-control on all of the interfaces.
clear ets counters
Clear all ETS TLV counters on an interface.
Syntax
clear ets counters port-type slot/port
Parameters
port-type Enter the keywords port-type then the slot/port information.
Defaults none
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the Z9500.
show interface ets
Displays the ETS configuration applied to egress traffic on an interface, including priority groups with priorities and bandwidth
allocation.
Syntax
show interface port-type fortyGigE/tenGigE X/x ets detail
Parameters
interface Enter the port-type which can be ten GigE or forty GigE and port ETS information.
detail Enter key details for a full list of results.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the Z9500.
Usage
Information
NOTE: Please note that the show interface ets detailsare updated with Minimum and
Maximum bandwidth details.
Example
(Summary)
Example (Detail)
Dell#show interface fortyGigE 0/36 ets detail
Interface fortyGigE 0/36
Max Supported PG is 4
506 Data Center Bridging (DCB)