White Papers

For address family: IPv4 Unicast
BGP neighbor is RR-CLIENT-PASSIV, peer-group internal,
Number of peers in this group 1
Peer-group members (* - outbound optimized):
9000::9:2*
FTOS#
show ip bgp ipv6 unicast summary
Allows you to view the status of all BGP connections.
C-Series, E-Series
Syntax
show ip bgp ipv6 unicast summary
Command Modes
● EXEC
● EXEC Privilege
Command
History
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Example
FTOS# show ip bgp summary
BGP router identifier 55.55.55.55, local AS number 18508
BGP table version is 0, main routing table version 0
6 BGP path attribute entrie(s) using 392 bytes of memory
6 BGP AS-PATH entrie(s) using 294 bytes of memory
6 BGP community entrie(s) using 234 bytes of memory
Neighbor AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/Pfx
1109::33 18508 0 0 0 0 0 never Active
2222::220 18508 0 0 0 0 0 never Active
4000::33 18508 0 0 0 0 0 never Active
4000::60 18508 0 0 0 0 0 never Active
9000::4:2 18508 0 0 0 0 0 never Active
9000::5:2 1 35 32 0 0 0 00:16:42 0
9000::6:2 2 35 32 0 0 0 00:16:39 0
9000::7:2 3 35 32 0 0 0 00:16:41 0
9000::8:2 18508 35 32 0 0 0 00:16:42 0
9000::9:2 18508 44 19 0 0 0 00:16:41 0
9000::a:2 18508 35 32 0 0 0 00:16:43 0
9000::b:14 18508 29 29 0 0 0 00:13:01 0
FTOS#
timers bgp
Allows you to adjust the BGP network timers for all neighbors.
C-Series, E-Series
Syntax
timers bgp keepalive holdtimer
To return to the default values, use the no timers bgp command.
Parameters
keepalive Enter the time interval in seconds between which the E-Series sends keepalive
messages. The range is 1 to 65535. The default is 60 seconds.
holdtimer Enter the time interval in seconds which the E-Series waits since the last keepalive
message before declaring a BGP peer dead. The range is 3 to 65535. The default is
180 seconds.
472 Border Gateway Protocol