White Papers

ManualsBrandsDell ManualsAccess PlatformsOS9

451

452

453

454

455

456

457

458

459

460

Table Of Contents

neighbor route-reflector-client

Configure a neighbor as a member of a route reflector cluster.

C-Series, E-Series

Syntax

neighbor {ipv6-address | peer-group-name} route-reflector-client

To indicate that the neighbor is not a route reflector client or to delete a route reflector configuration,

use the no neighbor {ipv6-address | peer-group-name} route-reflector-client

command.

Parameters

ipv6-address

Enter the IPv6 address in the x:x:x:x::x format.

NOTE: The :: notation specifies successive hexadecimal fields of zeros.

peer-group-name

Enter the name of the peer group. All routers in the peer group receive routes from

a route reflector.

Defaults Not configured.

Command Modes ROUTER BGPV6-ADDRESS FAMILY

Command

History

Version 8.2.1.0 Introduced on the E-Series ExaScale.

Version 7.4.1.0 Introduced

Usage

Information

The first time you enter this command it configures the neighbor as a route reflector and members of the

route-reflector cluster. Internal BGP (IBGP) speakers do not need to be fully meshed if you configure a

route reflector.

When all clients of a route reflector are disabled, the neighbor is no longer a route reflector.

neighbor send-community

Send a COMMUNITY attribute to a BGP neighbor or peer group. A COMMUNITY attribute indicates that all routes with that

attribute belong to the same community grouping.

C-Series, E-Series

Syntax

neighbor {ipv6-address | peer-group-name} send-community

To disable sending a COMMUNITY attribute, use the no neighbor {ipv6-address | peer-

group-name} send-community command.