White Papers

capture bgp-pdu max-buffer-size
Set the size of the BGP packet capture buffer. This buffer size pertains to both IPv4 and IPv6 addresses.
C-Series, E-Series
Syntax
capture bgp-pdu max-buffer-size 100-102400000
Parameters
100-102400000 Enter a size for the capture buffer.
Defaults 40960000 bytes
Command Modes
● EXEC
● EXEC Privilege
Command
History
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.5.1.0 Introduced
Related
Commands
● show capture bgp-pdu neighbor – configures a route reflector and clients.
● capture bgp-pdu neighbor – enables capture of an IPv4 BGP neighbor packet.
capture bgp-pdu neighbor (ipv6)
Enable capture of an IPv6 BGP neighbor packet.
C-Series, E-Series
Syntax
capture bgp-pdu neighbor ipv6-address direction {both | rx | tx}
To disable capture of the IPv6 BGP neighbor packet, use the no capture bgp-pdu neighbor
ipv6-address command.
Parameters
ipv6-address Enter the IPv6 address of the target BGP neighbor.
direction {both |
rx | tx}
Enter the keyword direction and a direction— either rx for inbound, tx for
outbound, or both.
Defaults Not configured.
Command Modes
● EXEC
● EXEC Privilege
Command
History
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.5.1.0 Introduced
Related
Commands
● clear ip bgp – enables route reflection between route reflector and clients.
● show capture bgp-pdu neighbor – configures a route reflector and clients.
● capture bgp-pdu neighbor – enables capture of an IPv4 BGP neighbor packet.
434 Border Gateway Protocol