White Papers

Version Description
9.2(1.0) Introduced on the Z9500.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.6.1.0 Introduced on the E-Series.
Usage
Information
Duplicate commands are silently accepted.
Example
Dell(conf-ext-community-list)#permit regexp 123
Dell(conf-ext-community-list)#
Related
Commands
deny regex — denies a community using a regular expression.
set extcommunity rt
To set Route Origin community attributes in Route Map, use this feature.
Syntax
set extcommunity rt {as4 ASN4:NN [non-trans] | ASN:NNNN [non-trans] |
IPADDR:NN [non-trans]} [additive]
To delete the Route Origin community, use the no set extcommunity command.
Parameters
as4 ASN4:NN Enter the keyword as4 then the 4-octet AS specific extended community number
in the format ASN4:NN (4-byte AS number:2-byte community value).
ASN:NNNN Enter the 2-octet AS specific extended community number in the format
ASN:NNNN (2-byte AS number:4-byte community value).
IPADDR:NN Enter the IP address specific extended community in the format IPADDR:NN (4-
byte IPv4 Unicast Address:2-byte community value).
additive (OPTIONAL) Enter the keyword additive to add to the existing extended
community.
non-trans (OPTIONAL) Enter the keywords non-trans to indicate a non-transitive BGP
extended community.
Defaults none
Command Modes ROUTE MAP (config-route-map)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T
8.3.11.1 Introduced on the Z-9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
418 Border Gateway Protocol