White Papers

Item Description
Authentication:... States whether authentication is configured for the VRRP group. If it is configured,
this lists the authentication type and password.
Tracking states.. Displays if the track command is configured on an interface. Also displays the
following information about the tracked interface:
● Dn or Up states whether the interface is down or up.
● The interface type slot/port information.
Example
DellEMC> show vrrp
------------------
TenGigabitEthernet 1/3, VRID: 1, Net: 10.1.1.253
VRF: 0 default
State: Master, Priority: 105, Master: 10.1.1.253 (local)
Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec
Adv rcvd: 0, Adv sent: 1862, Gratuitous ARP sent: 0
Virtual MAC address:
00:00:5e:00:01:01
Virtual IP address:
10.1.1.252
Authentication: (none)
Tracking states for 1 interfaces:
Up TenGigabitEthernet 1/17 priority-cost 10
------------------
TenGigabitEthernet 1/4, VRID: 2, Net: 10.1.2.253
VRF: 0 default
State: Master, Priority: 110, Master: 10.1.2.253 (local)
Hold Down: 10 sec, Preempt: TRUE, AdvInt: 1 sec
Adv rcvd: 0, Adv sent: 1862, Gratuitous ARP sent: 0
Virtual MAC address:
00:00:5e:00:01:02
Virtual IP address:
10.1.2.252
Authentication: (none)
Tracking states for 2 interfaces:
Up TenGigabitEthernet 2/1 priority-cost 10
Up TenGigabitEthernet 1/17 priority-cost 10
DellEMC>
version
Set the VRRP protocol version for the IPv4 group.
Syntax
version {2 | 3 | both}
To return to the default setting, use the no version command.
Parameters
2 Enter the keyword 2 to specify VRRP version 2 as defined by RFC 3768, Virtual
Router Redundancy Protocol.
3 Enter the keyword 3 to specify VRRP version 3 as defined by RFC 5798, Virtual
Router Redundancy Protocol.
both Enter the keyword both for in-service migration from VRRP version 2 to VRRP
version 3.
Defaults 2
Command Modes VRRP
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Virtual Router Redundancy Protocol (VRRP) 1695