White Papers

range Configure interface range
sonet SONET interface
tengigabitethernet TenGigabit Ethernet interface
vlan VLAN interface
Dell(conf)#interface gigabitethernet 1/1
Dell(conf-if-gi-1/1)#?
end Exit from configuration mode
exit Exit from interface configuration mode
Dell(conf-if-gi-1/1)#exit
Dell(conf)#line ?
aux Auxiliary line
console Primary terminal line
vty Virtual terminal
Dell(conf)#line vty 0
Dell(config-line-vty)#?
exit Exit from line configuration mode
Dell(config-line-vty)#
Applying a Privilege Level to a Username
To set the user privilege level, use the following command.
● Configure a privilege level for a user.
CONFIGURATION mode
username username privilege level
Applying a Privilege Level to a Terminal Line
To set a privilege level for a terminal line, use the following command.
● Configure a privilege level for a terminal line.
Line mode
privilege level level
NOTE:
When you assign a privilege level between 2 and 15, access to the system begins at EXEC mode, but the prompt is
hostname#, rather than hostname>.
Configuring Logging
The Dell Networking OS tracks changes in the system using event and error messages.
By default, Dell Networking OS logs these messages on:
● the internal buffer
● console and terminal lines
● any configured syslog servers
To disable logging, use the following commands.
● Disable all logging except on the console.
CONFIGURATION mode
no logging on
● Disable logging to the logging buffer.
CONFIGURATION mode
no logging buffer
● Disable logging to terminal lines.
CONFIGURATION mode
no logging monitor
● Disable console logging.
64
Switch Management