White Papers

interface TenGigabitEthernet 2/9
no ip address
shutdown
Resetting an Interface to its Factory Default State
You can reset the configurations applied on an interface to its factory default state. To reset the configuration, perform the
following steps:
1. View the configurations applied on an interface.
INTERFACE mode
show config
DellEMC(conf-if-te-1/5)#show config
!
interface TenGigabitEthernet 1/5
no ip address
portmode hybrid
switchport
rate-interval 8
mac learning-limit 10 no-station-move
no shutdown
2. Reset an interface to its factory default state.
CONFIGURATION mode
default interface interface-type]
DellEMC(conf)#default interface tengigabitethernet 1/5
3. Verify the configuration.
INTERFACE mode
show config
DellEMC(conf-if-te-1/5)#show config
!
interface TenGigabitEthernet 1/5
no ip address
shutdown
All the applied configurations are removed and the interface is set to the factory default state.
Enabling Energy Efficient Ethernet
Energy Efficient Ethernet (EEE) is an IEEE 802.3 az standard that reduces power consumptions on Ethernet ports. EEE stops
the transmission when there is no data to be transmitted and resumes the transmission at the arrival of new packets. You can
enable EEE only on ten Gigabit native or optional module copper ports.
1. To enable EEE, use the eee command.
INTERFACE mode
Dell(conf)# interface tengigabitethernet 1/1
Dell(conf-if-te-1/1)# eee
2. To disable EEE, use the no eee command.
INTERFACE mode
Dell(conf)# interface tengigabitethernet 1/1
Dell(conf-if-te-1/1)# no eee
Interfaces
363