Administrator Guide

Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Related
Commands
ip ssh server — enables the secure shell (SSH) server on the system.
ip telnet server vrf
Configures the TELNET server on either a specific VRF or a management VRF.
Syntax ip telnet server vrf {management | vrf-name}
To undo the TELNET server configuration, use the no ip telnet server [vrf vrf-name]
command.
Parameters
vrf management Enter the keyword vrf followed by the keyword management to specify a
management VRF that is used by the TELNET server.
vrf vrf-name Enter the keyword vrf and then the name of the VRF to specify the VRF that is
used by the TELNET server.
Defaults Disabled
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.4.(0.0) Introduced on the S-Series and Z9000.
Usage
Information
You can enable the TELNET server on either a management VRF or a user-defined VRF but not both. If
you do not specify a VRF name, then the TELNET server is enabled on the default VRF.
Example
Dell(conf)#ip telnet server vrf vrf1
Dell(conf)#no ip telnet server vrf
Dell(conf)#ip telnet server vrf management
Dell(conf)#no ip telnet server vrf
98 Control and Monitoring