Administrator Guide

Version Description
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
9.0.2.0 Introduced on the S6000.
9.0.2.0 Introduced on the MXL.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage
Information
The monitor command is saved in the running configuration at Monitor Session mode level and can be
restored after a chassis reload.
Example
Dell#show monitor session
SessID Source Destination Dir Mode Source IP
Dest IP DSCP TTL
------ ------ ----------- --- ---- ---------
-------- ---- ---
0 Te 1/12 remote-ip rx Flow 1.1.1.1
7.1.1.2 0 255
0 Po 1 remote-ip tx Flow 1.1.1.1
7.1.1.2 0 255
1 Vl 11 remote-ip rx Flow 5.1.1.1
3.1.1.2 0 255
Related
Command
show monitor session — displays the monitor session.
show running-config monitor session — displays the running configuration of a monitor session.
show config
Display the current monitor session configuration.
Syntax
show config
Defaults none
Command Modes MONITOR SESSION (conf-mon-sess-session-ID)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.7.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Example
Dell(conf-mon-sess-1)#show config
!
976 Port Monitoring