Administrator Guide

Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.4.1.0 Introduced on the E-Series ExaScale.
Example
Dell#show running-config pim
!
ip pim snooping enable
IPv6 PIM-Sparse Mode Commands
The following describes the IPv6 PIM-sparse mode (PIM-SM) commands.
ipv6 pim bsr-border
Invoke IPv6 PIM debugging.
Syntax
debug ipv6 pim [bsr | events | group group | packet | register [group] |
state | | timer [assert | hello | joinprune | register]]
To disable IPv6 PIM debugging, use the no debug ipv6 pim command.
Parameters
bsr (OPTIONAL) Enter the keyword bsr to invoke debugging of IPv6 PIM Candidate
RP/BSR activities.
events (OPTIONAL) Enter the keyword events to invoke debugging of IPv6 PIM events.
group group (OPTIONAL) Enter the keyword group then the group address to invoke
debugging on that specific group.
packet (OPTIONAL) Enter the keyword packet to invoke debugging of IPv6 PIM packets.
register [ group ] (OPTIONAL) Enter the keyword register and optionally the group address to
invoke debugging of IPv6 PIM register messages for a particular group.
state (OPTIONAL) Enter the keyword state to view IPv6 PIM state changes.
timer [assert |
hello | joinprune |
register]
(OPTIONAL) Enter the keyword timer to view IPv6 PIM timers. Enter one of the
optional parameters:
● assert: to view the assertion timer
● hello: to view the IPv6 PIM neighbor keepalive timer
● joinprune: to view the expiry timer (join/prune timer)
● register: to view the register suppression timer
Defaults Disabled.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
PIM-Sparse Mode (PIM-SM) 963