Administrator Guide

Parameters
seconds Enter the number of seconds the S, G entries are retained. The range is from 211 to
65535.
Defaults Disabled. The default expiry timer (with no times configured) is 210 sec.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.5(0.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the C-Series for the port-channels and the S-Series.
7.7.1.1 Introduced
Usage
Information
This command configures an expiration timer for all S.G entries, unless they are assigned to an Extended
ACL.
Even though the FHR nodes act as RPs, these nodes still send Register encap messages to themselves
and expect to receive a Register stop message (for Anycast RP support). As a result, if the DLT timer
expires, SG is not deleted until the register state is deleted in the node. This register state expires 210
seconds after the last Null register is received.
ip pim ssm-range
Specify the SSM group range using an access list.
Syntax
ip pim ssm-range {access_list_name}
Parameters
access_list_name Enter the name of the access list.
Defaults Default SSM range is 232/8 and ff3x/32
Command Modes CONFIGURATION
Command
History
Version Description
9.7(0.0) Introduced on the S6000-ON. Added support for VRF on S6000, S4810, S4820T,
Z9000, Z9500, and S6000–ON.
9.5(0.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
950 PIM-Sparse Mode (PIM-SM)