Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

941

942

943

944

945

946

947

948

949

950

Table Of Contents

Parameters

priority-value

Enter a number. Preference is given to larger/higher number. The range is from 0

to 4294967294. The default is 1.

Defaults 1

Command Modes INTERFACE

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.7(0.0) Introduced on the S6000-ON.

9.5(0.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

8.1.1.0 Introduced on the E-Series ExaScale.

7.8.1.0 Introduced on the C-Series on port-channels and the S-Series.

Usage

Information

The router with the largest value assigned to an interface becomes the designated router. If two

interfaces contain the same designated router priority value, the interface with the largest interface IP

address becomes the designated router.

ip pim join-filter

Permit or deny PIM Join/Prune messages on an interface using an extended IP access list. This command prevents the PIM-SM

router from creating state based on multicast source and/or group.

Z9000

Syntax

ip pim join-filter ext-access-list

To remove the access list, use the no ip pim join-filter ext-access-list command.