Administrator Guide

● fin = finish (no more data from the user)
● psh = push function
● rst = reset the connection
● syn = synchronize sequence number
● urg = urgent field
source Enter the IP address of the network or host from which the packets were sent.
mask Enter a network mask in /prefix format (/x).
any Enter the keyword any to specify that all traffic is subject to the filter.
host ip-address Enter the keyword host then the IP address to specify a host IP address.
destination Enter the IP address of the network or host to which the packets are sent.
operator (OPTIONAL) For TCP and UDP parameters only. Enter one of the following logical
operand:
● eq = equal to
● neq = not equal to
● gt = greater than
● lt = less than
● range = inclusive range of ports (you must specify two ports for theport
command parameter.)
Defaults none
Command Modes REDIRECT-LIST
Command
History
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Added support for the track-id on the S4810, S4820T, S6000, and Z9000.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
8.4.2.1 Introduced on the C-Series and S-Series.
8.4.2.0 Introduced on the E-Series Tera Scale.
7.7.1.0 Introduced on the E-Series ExaScale.
seq
Configure a filter with an assigned sequence number for the redirect list.
Z9000
Syntax
seq sequence-number {permit | redirect {ip-address | tunnel tunnel-id}
[track <obj-id>] }} {ip-protocol-number | protocol-type} {source mask
| any | host ip-address} {destination mask | any | host ip-address}
[bit] [operator]{source-port source-port| source-port-range start-port -
end-port} {destination-port destination-port| destination-port-range start-
port - end-port}
To delete a filter, use the no seq sequence-number command.
Parameters
sequence-
number
Enter a number from 1 to 65535.
permit Enter the keyword permit assign the sequence to the permit list.
redirect Enter the keyword redirect to assign the sequence to the redirect list.
936 Policy-based Routing (PBR)