Administrator Guide

Table Of Contents
lt= less than
range = inclusive range of ports (you must specify two ports for the
portcommand parameter.)
Defaults none
Command Modes REDIRECT-LIST
Command
History
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
8.4.2.1 Introduced on the C-Series and S-Series.
8.4.2.0 Introduced on the E-Series Tera Scale.
7.7.1.0 Introduced on the E-Series ExaScale.
redirect
Configure a rule for the redirect list.
Z9000
Syntax
redirect {ip-address | slot/port} | tunnel tunnel-id}[track <obj-id>] {ip-
protocol-number | protocol-type [bit]} {source mask | any | host ip-
address} {destination mask | any | host ip-address} [operator]
To remove this filter, use one of the following:
Use the no seq sequence-number command if you know the filters sequence number.
You can also use the no redirect {ip-address | slot/port}| tunnel tunnel-id}
[track <obj-id>] {ip-protocol-number [bit] | protocol-type} {source mask
| any | host ip-address} {destination mask | any | host ip-address}
[operator] command.
Parameters
redirect Enter the keyword redirect to assign the sequence to the redirect list.
ip-address
Enter the IP address of the forwarding router.
slot/port
Enter the keyword slot / port followed by the slot/port information.
tunnel
Enter the keyword tunnel to configure the tunnel setting.
tunnel-id
Enter the keyword tunnel-id to redirect the traffic.
track
Enter the keyword track to enable the tracking.
track <obj-id>
Enter the keyword track <obj-id> to track object-id.
ip-protocol-
number
Enter a number from 0 to 255 for the protocol identified in the IP protocol header.
protocol-type
Enter one of the following keywords as the protocol type:
icmp for internet control message protocol
ip for any internet protocol
tcp for transmission control protocol
udp for user datagram protocol
bit
(OPTIONAL) For the TCP protocol type only, enter one or a combination of the
following TCP flags:
ack = acknowledgement
Policy-based Routing (PBR) 935