Administrator Guide

To remove an IPsec encryption policy from an interface, enter the no area area-id encryption spi number
command.
Related
Commands
ipv6 ospf encryption – configures an IPsec encryption policy on an OSPFv3 interface.
show crypto ipsec policy – display the configuration of IPsec encryption policies.
clear ipv6 ospf process
Reset an OSPFv3 router process without removing or re-configuring the process.
Z-Series
Syntax
clear ipv6 ospf process
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.1.(0.0) Introduced on the S4810 and Z9000.
8.3.19.0 Introduced on the S4820T.
7.8.1.0 Added support for C-Series.
7.4.1.0 Introduced on the E-Series.
debug ipv6 ospf bfd
Display debug information and interface types for bidirectional forwarding detection (BFD) on OSPF IPv6 packets.
Z9000
Syntax
[no] debug ipv6 ospf bfd [interface]
Parameters
interface
(OPTIONAL) Enter one of the following keywords and slot/port or number
information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a port channel interface, enter the keywords port-channel then a
number. The range is from 1 to 128.
● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
910 Open Shortest Path First (OSPFv2 and OSPFv3)