Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

851

852

853

854

855

856

857

858

859

860

Table Of Contents

isis (OPTIONAL) Enter the keyword isis to specify that IS-IS routes are distributed.

NOTE: BGP and ISIS routes are not available on the C-Series. BGP, ISIS, and

RIP routes are not available on the S-Series.

rip (OPTIONAL) Enter the keyword rip to specify that RIP routes are distributed.

NOTE: BGP and ISIS routes are not available on the C-Series. BGP, ISIS, and

RIP routes are not available on the S-Series.

static (OPTIONAL) Enter the keyword static to specify that only manually configured

routes are distributed.

Defaults Not configured.

Command Modes ROUTER OSPF

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.8.1.0 Added support for the Multi-Process OSPF.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

pre- 6.1.1.1 Introduced on the E-Series.

Usage

Information

The distribute-list out command applies to routes autonomous system boundary routers

(ASBRs) redistributes into OSPF. It can be applied to external type 2 and external type 1 routes, but

not to intra-area and inter-area routes.

enable inverse-mask

By default, Dell Networking Operating System (OS) allows you to input the OSPF network command with a net-mask. This

command provides a choice between inverse-mask or net-mask (the default).

Z9000

Syntax

enable inverse mask

To return to the default net-mask, use the no enable inverse mask command.

Defaults net-mask

Command Modes CONFIGURATION