Administrator Guide

Related
Commands
area stub — creates a stub area.
router ospf — enters ROUTER OSPF mode to configure an OSPF instance.
area stub
Configure a stub area, which is an area not connected to other areas.
Z9000
Syntax
area area-id stub [no-summary]
To delete a stub area, use the no area area-id stub command.
Parameters
area-id Specify the OSPF area in dotted decimal format (A.B.C.D.) or enter a number from
zero (0) to 65535.
no-summary (OPTIONAL) Enter the keywords no-summary to prevent the ABR from sending
summary Link State Advertisements (LSAs) into the stub area.
Defaults Disabled.
Command Modes ROUTER OSPF
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support for the Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Usage
Information
To configure all routers and access servers within a stub, use this command.
Related
Commands
router ospf — enters ROUTER OSPF mode to configure an OSPF instance.
auto-cost
Specify how the OSPF interface cost is calculated based on the reference bandwidth method.
Z9000
Syntax
auto-cost [reference-bandwidth ref-bw]
848 Open Shortest Path First (OSPFv2 and OSPFv3)