Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

Table Of Contents

The total amount of space allowed is 16 FP Blocks. System flow requires three blocks and these blocks

cannot be reallocated. The ipv4acl profile range is from 1 to 4.

When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.

Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which is from 0 to 10. The

ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).

If you enabled BMP, to perform a reload on the chassis to upgrade any configuration changes that have

changed the NVRAM content, use the reload conditional nvram-cfg-change command.

clear alarms

Clear alarms on the system.

Syntax

clear alarms

Command Modes EXEC Privilege

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0 Introduced on the S6000.

Version 8.3.19.0 Introduced on the S4820T.

Version 8.3.12.0 Introduced on the S4810.

Version 8.3.11.1 Introduced on the Z9000.

Version 8.1.1.0 Introduced on the E-Series ExaScale.

Version 7.6.1.0 Introduced on the S-Series.

Version 7.5.1.0 Introduced on the C-Series.

E-Series Original command.

Usage

Information

This command clears alarms that are no longer active. If an alarm situation is still active, it is seen in the

system output.

clear command history

Clear the command history log.