Administrator Guide

ipv6 nd ra-guard attach-policy
Apply the IPv6 RA guard to a specific interface.
Syntax
ipv6 nd ra-guard attach—policy policy-name [vlan [vlan 1, vlan 2, vlan
3.....]]
Parameters
policy policy-
name
Enter the keyword policy then the policy name. The policy-name allows a
maximum of 140 characters.
vlan [vlan 1, vlan
2, vlan 3........]
Enter the keyword vlan then the VLAN range. The VLAN range is from 1 to 4094.
Defaults none
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, and Z9000 switches.
Related
Commands
show ipv6 nd ra-guard policy — Displays the configuration applied on all the RA guard policies or a
specific RA guard policy.
ipv6 nd ra-guard enable
Allow you to configure the RA guard related commands.
Syntax
ipv6 nd ra-guard enable
To disable the RA guard, use the no ipv6 nd ra-guard enable command.
Defaults Disabled
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, and Z9000 switches.
ipv6 nd ra-guard policy
Define the RA guard policy name and enter the RA guard policy list configuration mode.
Syntax
ipv6 nd ra-guard policy policy-name
Parameters
policy policy-
name
Enter the keyword policy then the policy-name. The policy name allows a
maximum of 140 characters.
Defaults none
Command Modes CONFIGURATION
Neighbor Discovery Protocol (NDP) 821