Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

811

812

813

814

815

816

817

818

819

820

Table Of Contents

device-role

Specify the role of the device attached to the port.

Syntax

device-role {host | router}

To reset the device role, use the no device-role {host | router} command.

Parameters

host Enter the keyword host to set the device-role as host.

router Enter the keyword router to set the device-role as router.

Defaults none

Command Modes POLICY LIST CONFIGURATION

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.7(0.0) Introduced on the S6000-ON.

9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, and Z9000 switches.

Commands

● ipv6 nd raguard policy policy-name — Defines the RA guard policy name and enter the RA guard

policy configuration mode.

● ipv6 nd ra-guard enable — Allows you to configure the RA guard related commands.

hop-limit

Enable the verification of the advertised hop count limit. If this command is not configured, the verification process is bypassed.

Syntax

hop-limit {maximum | minimum limit}

To reset the hop count limit, use the no hop-limit {maximum | minimum limit} command.

Parameters

maximum

limit

Enter the keyword maximum then the hop limit value. The range is from 0 to 254.

minimum