Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

811

812

813

814

815

816

817

818

819

820

Table Of Contents

NOTE: The :: notation specifies successive hexadecimal fields of zero.

interface

To remove all neighbor entries learned on a specific interface, enter the keyword

interface then the interface type and slot/port or number information of the

interface:

● For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the

slot/port information.

● For a port channel interface, enter the keywords port-channel then a

number.

● For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.

Command Modes

● EXEC

● EXEC Privilege

Command

History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.7(0.0) Introduced on the S6000-ON.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.1 Introduced on the S4810.

debug ipv6 nd ra-guard

Enable debugging for IPv6 RA guard snooping information.

Syntax

debug ipv6 nd ra-guard [interface_type slot/port | count value]

Parameters

interface_type

slot/port

Enter the one of the following interfaces and slot/port information:

● For a port channel interface, enter the keywords port-channel then a

number.

● For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the

slot/port information.

count

value

Enter the keyword count then the number of debug outputs. The range is from 1

to 65534. The default is infinity.

Defaults none

Command Modes EXEC Privilege