Administrator Guide

• show command-history
• show command-tree
• show cpu-traffic-stats
• show debugging
• show inventory
• show processes ipc flow-control
• show software ifm
• show system
• show tech-support
• ssh-peer-stack-unit
• telnet
• telnet-peer-stack-unit
• terminal length
• traceroute
• undebug all
• virtual-ip
• write
asf-mode
Enable alternate store and forward (ASF) mode and forward packets as soon as a threshold is reached.
Syntax
asf-mode stack-unit {unit-id | all} queue size
To return to standard Store and Forward mode, use the no asf-mode stack unit command.
Parameters
unit-id Enter the stack member unit identifier of the stack member to reset. The Z9000
range is from 0 to 7.
queue size Enter the queue size of the stack member. The range is from 0 to 15.
Defaults Not configured
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
8.3.19.0 Introduced on the S4820T.
8.3.11.0 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage
Information
You must save the configuration and reload the system to implement ASF. When you enter the command,
the system sends a message stating that the new mode is enabled when the system reloads.
banner exec
Configure a message that is displayed when your enter EXEC mode.
Syntax
banner exec c line c
To delete a banner, use the no banner exec command.
78 Control and Monitoring