Administrator Guide

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Image upgraded to all
upgrade fpga-image
Use this command only on systems with SFM3 modules (and only when required by the Upgrade Procedure in the release
notes).
Z9000
Syntax
upgrade fpga-image {sfm} {all | id} [booted | flash:// | ftp: |slot0: |
tftp] file-url
Parameters
sfm Enter the keyword sfm to upgrade the FPGA on the SFMs.
all Enter the keyword all to upgrade the FPGA on all the SFMs.
id Enter the keyword id to upgrade the FPGA on all a specific SFM.
booted Enter the path to the upgrade source. Entering <CR> updates the FPGA from the
flash.
file-url Enter the following location keywords and information to upgrade the FPGA using
an Dell Networking OS image other than the one currently running:
● To specify an Dell Networking OS image on the internal flash, enter flash://
file-path/filename.
● To specify an Dell Networking OS image on an FTP server, enter ftp://
user:password@hostip/filepath.
● To specify an Dell Networking OS image on the external flash on the primary
RPM, enter slot0://file-path/filename.
● To copy a file on a TFTP server, enter tftp://hostip/filepath/
filename where hostip is either an IPv4 dotted decimal address or an IPv6
URI [x:x:x:x::x] format address..
Defaults none
Command Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.0.0 Introduced on the Z-Series.
Version 8.3.1.0 Added the rpm option.
Version 7.5.1.0 Introduced on the C-Series.
Example
Dell#upgrade sfm 1 autoreset
SFM1: upgrade in progress
!!! !!! !!!
SFM1: upgrade complete
SFM1 is active. Resetting it might temporarily impact traffic.
Proceed with reset [confirm yes/no]: yes
Dell#
Usage
Information
Reset the card using the power-cycle option after restoring the FPGA command.
File Management 75