Administrator Guide

Column
Heading
Description
Type Lists whether the MAC address was manually configured (Static), learned
(Dynamic), or associated with a specific port (Sticky). An (N) indicates that the
specified MAC address has been learnt by a neighbor and is synced to the node.
Interface Displays the interface type and slot/port information. The following abbreviations
describe the interface types:
● gi — Gigabit Ethernet followed by a slot/port
● po — Port Channel followed by a number. Range for Terascale is from 1 to 255.
\
● te — 10–Gigabit Ethernet followed by a slot/port.
State Lists if the MAC address is in use (Active) or not in use (Inactive).
The following describes the show mac-address-table count command shown in the following
example.
Line
Beginning
With
Description
MAC Entries... Displays the number of MAC entries learned per VLAN.
Dynamic
Address...
Lists the number of dynamically learned MAC addresses.
Static Address... Lists the number of user-defined MAC addresses.
Total MAC... Lists the total number of MAC addresses the switch uses.
Example (Count)
Dell# show mac-address-table count
MAC Entries for all vlans :
Dynamic Address Count : 110
Static Address (User-defined) Count : 0
Sticky Address Count : 0
Total Synced Mac from Peer(N): 100
Total MAC Addresses in Use: 110
Dell#
Related
Commands
show mac-address-table aging-time — displays MAC aging time.
show mac-address-table aging-time
Display the aging times assigned to the MAC addresses on the switch.
Z9000
Syntax
show mac-address-table aging-time [vlan vlan-id]
Parameters
vlan vlan-id (OPTIONAL) Enter the keyword vlan then the VLAN ID to display the MAC
address assigned to the VLAN. The range is from 1 to 4094.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Layer 2 739