Administrator Guide

mac learning-limit station-move-violation
Specify the actions for a station move violation.
Z9000
Syntax
mac learning-limit station-move-violation {log | shutdown-both | shutdown-
offending | shutdown-original}
To disable a configuration, use the no mac learning-limit station-move-violation
command, then the configured keyword.
Parameters
log Enter the keyword log to generate a syslog message on a station move violation.
shutdown-both Enter the keyword shutdown to shut down both the original and offending
interface and generate a syslog message.
shutdown-
offending
Enter the keywords shutdown-offending to shut down the offending interface
and generate a syslog message.
shutdown-
original
Enter the keywords shutdown-original to shut down the original interface and
generate a syslog message.
Defaults none
Command Modes INTERFACE (conf-if-interface-slot/port)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
7.5.1.0 Introduced on the E-Series.
Usage
Information
This command is supported on physical interfaces, static LAGs, and LACP LAGs.
Related
Commands
show mac learning-limit — displays details of the mac learning-limit.
mac learning-limit reset
Reset the MAC address learning-limit error-disabled state.
Z-Series
Syntax
mac learning-limit reset
Defaults none
734 Layer 2