Administrator Guide

Version 9.0.2.0 Introduced on the S6000.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Added support for sticky MAC addresses.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.1.1.1 Introduced on the E-Series.
mac-address-table aging-time
Specify an aging time for MAC addresses to remove from the MAC address table.
Z9000
Syntax
mac-address-table aging-time seconds
Parameters
seconds Enter either zero (0) or a number as the number of seconds before MAC addresses
are relearned. To disable aging of the MAC address table, enter 0. The range is
from 10 to 1000000. The default is 1800 seconds.
Defaults 1800 seconds
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 On the E-Series, available in INTERFACE VLAN context, reduced the minimum
aging time in the INTERFACE VLAN context from 10 seconds to 1 second.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.1 Introduced on the E-Series.
Related
Commands
mac learning-limit — sets the MAC address learning limits for a selected interface.
show mac-address-table aging-time — displays the MAC aging time.
728 Layer 2