Administrator Guide

Link Aggregation Control Protocol (LACP)
This chapter contains commands for Dell Networks’s implementation of the link aggregation control protocol (LACP) for
creating dynamic link aggregation groups (LAGs) — known as “port-channels” in the Dell Networking operating software. The
LACP commands in this chapter are supported by Dell Networking OS on the Z9000 platform.
NOTE: For static LAG commands, refer to Port Channel Commands in the Interfaces chapter), based on the standards
specified in the IEEE 802.3 Carrier sense multiple access with collision detection (CSMA/CD) access method and physical
layer specifications.
Topics:
• clear lacp counters
• debug lacp
• lacp long-timeout
• lacp port-priority
• lacp system-priority
• port-channel mode
• port-channel-protocol lacp
• show lacp
• hg-link-bundle-monitor
• hg-link-bundle-monitor trigger-threshold
• hg-link-bundle-monitor rate-interval
• show hg-link-bundle-distribution
• snmp-server enable traps (for High-Gigabit Port Channel)
• show hardware stack-unit (for high-Gigabit Ethernet ports)
• clear hardware stack-unit (for high-Gigabit Ethernet ports)
clear lacp counters
Clear port channel counters.
Z9000
Syntax
clear lacp port-channel-number counters
Parameters
port-channel-
number
Enter a port-channel number. The range is from 1 to 128.
Defaults Without a Port Channel specified, the command clears all Port Channel counters.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
27
Link Aggregation Control Protocol (LACP) 715