Administrator Guide

Version Description
8.3.7.0 Introduced on the S4810.
8.4.2.1 Introduced on the S-Series.
Usage
Information
Host tables are not stored in CAM tables on S-Series platforms. Entries for camIndex displays as zero
(0) on the show ipv6 fib stack-unit output for neighbor entries, such as address resolution
protocol (ARP) entries.
show ipv6 flowlabel-zero
Display the flow label zero setting.
Z9000
Syntax
show ipv6 flowlabel-zero
Default Disabled
Command Modes EXEC
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Related
Commands
ipv6 nd dad attempts — Configure system to set the flow label field in the packets to zero.
show ipv6 interface
Display the status of interfaces configured for IPv6.
Z9000
Syntax
show ipv6 interface interface [brief] [configured] [loopback interface-
number] [managementethernet slot/port] [port-channel number] [stack-unit
id] [tengigabitethernet slot | slot/port] [fortyGigE slot | slot/port]
[tunnel tunnel-id] [vlan vlan-id]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
● For a Loopback interface, enter the keyword loopback then a number from 0
to 16383.
● For a port channel interface, enter the keywords port-channel then a
number.
IPv6 Basics 657