Administrator Guide

show ipv6 cam stack-unit
Displays the IPv6 CAM entries for the specified stack-unit.
Syntax
show ipv6 cam [vrf vrf-name] stack-unit unit-number port-set {0-1} [summary
| index | ipv6 address]
Parameters
vrf vrf-name (Optional) Enter the keyword vrf followed by the name of the VRF to display IPv6
CAM entries corresponding to that VRF.
NOTE: If you do not specify this option, IPv6 CAM entries corresponding to
the default VRF are displayed.
unit-number Enter the stack unit’s ID number.
port-set Enter the keyword Port Set.
summary (OPTIONAL) Enter the keyword summary to display a table listing network
prefixes and the total number prefixes which can be entered into the IPv6 CAM.
index (OPTIONAL) Enter the index in the IPv6 CAM.
ipv6-address Enter the IPv6 address in the x:x:x:x::x/n format to display networks that have
more specific prefixes. The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
Defaults none
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for VRF.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.1 Introduced on the S4810.
8.4.2.1 Introduced on the S-Series.
Usage
Information
NOTE: If a route has a mask greater than 64, no output is displayed and no output is displayed
for show ipv6 cam stack-unit unit-number port-set {0-1} ipv6-address, but
an equivalent /64 entry would be listed in the show ipv6 cam stack-unit unit-number
port-set {0-1} output. Similarly, if there is more than one ECMP object with a destination route
that has a mask greater than 64, if the first 64 bits in the destination routes of the ECMP objects are
the same, only one route is installed in CAM even though multiple ECMP path entries exist.
IPv6 Basics 655