Administrator Guide

forwarding-
router-address
Enter an IP address (dotted decimal format) or an IPv6 address (x:x:x:x::x format)
of a forwarding router.
managementethe
rnet
Enter the keyword managementethernet for the Management interface on the
Primary RPM.
fortyGigE Enter the keyword fortyGigE to specify a forty Gigbit Ethernet interface.
vlan Enter the keyword vlan to specify a vlan interface.
tengigabitethern
et
Enter the keyword tengigabitethernet to specify a ten Gigabit Ethernete interface.
Defaults Not configured.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for forty gigabit, vlan, and tengigabit ethernet interfaces.
Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000 and added support for IPv6.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage
Information
When a static route (or a protocol route) overlaps with Management static route, the static route (or a
protocol route) is preferred over the Management Static route. Also, Management static routes and the
Management Connected prefix are not reflected in the hardware routing tables. Separate routing tables
are maintained for IPv4 and IPv6 management routes. This command manages both tables.
Related
Commands
interface ManagementEthernet — configures the Management port on the system (either the Primary or
Standby RPM).
speed (Management interface) — sets the speed for the Management interface.
show arp
Display the ARP table.
Z9000
Syntax
show arp [interface interface | ip ip-address [mask] | macaddress mac-
address [mac-address mask]] [retries] [static | dynamic] [inspection
{database | statistics][summary]
Parameters
interface
interface
(OPTIONAL) Enter the following keywords and slot/port or number information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
608 IPv4 Routing